---------------------- multipart/alternative attachment Adding alcohol to the solution ?? Alcohol shouldn't be wasted on removing the key bushings!!! ----- Original Message ----- From: Paul Chick \(Earthlink\) To: Pianotech Sent: 12/3/04 5:51:32 AM Subject: RE: Key Bushing removal Subject: Key Bushing removal Hi, I use the method of pre-soaking the keybushings with wallpaper remover and hot water and after that I just steam the bushings out with a similar hand held steam device with a small nozzle. Works verry fast and de wood is neat and clean for the new felt. Pierre Gevaert Belgium Hello....I use the same system...but let them penetrate and soak,,,,while I do some other job around the shop...an hour later they fall out with very little digging....and no damage to mortise...... Richard Add some alcohol to your solution to break the surface tension of the water and it will speed up absorption. Paul C ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/99/1c/7e/9b/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC