I would think that we need very little glue. I think hot hide glue if very thin with urea would be a good choice. We don't want any lumps. I had planned on a lite coat of 3M 77...probably still will use it. David I. ----- Original message ----------------------------------------> From: Joseph Garrett <joegarrett@earthlink.net> To: <pianotech@ptg.org> Received: Thu, 10 Jun 2004 08:12:10 -0700 Subject: Re: Hammer flange rail backing >David Love said: "Spray adhesive works >well and goes on evenly so as not to effect travel." >The best glue to use, in this application, is hide glue. Either hot or cold. >The easiest is cold hide glue. Spray on adhesive remains soft and therefore >will change the tightness of the flange screws and the travel, with time. I >don't recommend it. >Best Regards, >Joe Garrett, RPT, (Oregon) >Captain, Tool Police >Squares Are I >_______________________________________________ >pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC