This is a multipart message in MIME format ---------------------- multipart/alternative attachment Look again...that's where the screws are...a thin metal bar= inlaid in the side of the fallboard. Pull the fallboard down= 1/2 way... David I. ----- Original message ----------------------------------------> From: Richard Day <pianotoone@hotmail.com> To: <pianotech@ptg.org> Received: Sun, 13 Jun 2004 16:12:15 -0400 Subject: Re: Leonard Baby Gr Action Removal You cannot see the side of he fallboard. It is within about 1/32= inch from the sides opf the piano case. >From: ANRPiano@aol.com >Reply-To: Pianotech <pianotech@ptg.org> >To: pianotech@ptg.org >Subject: Re: Leonard Baby Gr Action Removal >Date: Sun, 13 Jun 2004 13:10:36 EDT > > >In a message dated 6/13/2004 11:49:35 AM Central Daylight Time,= >pianotoone@hotmail.com writes: > >The fallboard appears to have two pivot pins that go into the= side of the >piano. From the front looking at the fallboard, there is no = hardware visible. > > > >Look at the side of the fall board. Hold the fall board in a= half closed >position. > >They can be hard to see. > >Andrew ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/22/34/28/d3/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC