Bridge over troubled waters

[Ron Nossaman]

>I don't have any disagreement with Pianotek's recommendations.
>
>#46 (0.0810) for #7 (0.086)
>#42 (0.0935) for #8 (0.096)
>#36 (0.1065) for #9 (0.109)
>#30 (0.1285) for #10 (0.135)
>
>
>Ron N
>
>Thanks Ron.  I looked at their bit sizes and wondered if they might be a
>little too tight; will try them.
>
>Paul C


if you think so, there's

#45@0.082, or 2.15mm@0.0846 for #7
3/32@0.0938, or 2.4mm@0.0945 for #8
2.75mm@0.1083 for #9
3.3mm@0.1299, or 3.4mm@0.1339 for #10

Available - somewhere else... <G> Surely there's room for experimentation 
here, depending on capping material.

I like to drive them with a little epoxy, which tends to lubricate and 
soften up the hole some, so Pianotek's sizes seem to work OK for me, even 
in the laminated cap.

Ron N