---------------------- multipart/alternative attachment I sent off my other post before I read this. I would be curious to see whether or not the bore distance matches the difference between hammer flange center and string height. My guess is that the elevations don't match and that the hammers are bored too short. In that case, the easiest solution will be to shim the end of the balancier. Otherwise, you will have to pull the hammers, plug and rebore at the proper distance and then you might have a hammer tail length problem... David Love davidlovepianos@earthlink.net ----- Original Message ----- From: Mark Davidson To: Pianotech Sent: 5/13/2004 4:08:18 AM Subject: drop screw question >How is the rep spring tension? Have parts been replaced? What kind of = >piano? Age? Condition? > >Terry Farrell 5 year old Steinway L. Original parts. Rep spring tension on the high side in general, but I'll recheck the notes in question. -Mark ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/b0/d7/40/e0/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC