Hi Greg, That was my first thought also, but then That is where the staples are too. Joe Goss imatunr@srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Greg Newell" <gnewell@ameritech.net> To: "Pianotech" <pianotech@ptg.org> Sent: Saturday, May 15, 2004 6:09 PM Subject: jig > Dale, > How useful is this jig really? I've never seen a hammer supported > under the low shoulder are like your jig does. Perhaps if it were made to > support under the wooden end you might have a better representation of > what's actually going on under deformation. Then again, perhaps there would > not be an appreciable difference. > > Greg Newell > Greg's piano Forté > mailto:gnewell@ameritech.net > > > _______________________________________________ > pianotech list info: https://www.moypiano.com/resources/#archives
This PTG archive page provided courtesy of Moy Piano Service, LLC