Hello Ajay. You could also check if the pre-hung hammers you got are hung at the right distance on the shanks. A simple way to check this is to evaluate if the backchecks, when regulated albeit approximately, look like they have the usual 72° inclination with the key. If they look closer to 90 ° (that is vertical), you can be sure that the hammers are hung at a too close distance of the center pin, and causing that weight problem. Few millimeters are critical here. Maybe the center pin to hammer distance has varied from time to time or from models to models. Regards Stéphane Collin. > >
This PTG archive page provided courtesy of Moy Piano Service, LLC