OUT

[Joe And Penny Goss]

This is a multi-part message in MIME format.

---------------------- multipart/alternative attachment
THIMC
I will be offline one week or less.
Joe Goss RPT
Mother Goose Tools
imatunr@srvinet.com
www.mothergoosetools.com
  ----- Original Message -----=20
  From: Alan Barnard=20
  To: Pianotech=20
  Sent: Wednesday, August 03, 2005 8:31 PM
  Subject: Re: howard spinet


  To quote the robot: "Warning, Mr. Smith, Warning."

  If this is the action Joe describes here DO NOT remove sticker wires =
from the guide bar or let them fall out-MAJOR pain to get them all back =
you, AMHIK.

  Do what he said, put damper blocks on several wires ABOVE the rail and =
tighten the screws.=20

  Alan Barnard
  Salem, Missouri


    ----- Original Message -----=20
    From: Joe And Penny Goss=20
    To: Pianotech
    Sent: 08/03/2005 9:02:16 PM=20
    Subject: Re: howard spinet


    Ohoh. Is this the one with the wood rail with the stickers comming =
up through it?
    If it is you need 4 or 5 damper heads drilled out to, I think it is =
1/8 inch.
    You will capture the wire end of the sticker at the end of each =
section.
    This one is easy but still look for the brace. It may be a rod.
    Rough setting of lost motion can be done by adjusting the hight of =
the sticker rail.
    You will want to purchase a 12" long thin 1/8" screwdriver.
    Joe Goss RPT
    Mother Goose Tools
    imatunr@srvinet.com
    www.mothergoosetools.com
      ----- Original Message -----=20
      From: richard.ucci@att.net=20
      To: pianotech@ptg.org=20
      Sent: Wednesday, August 03, 2005 7:06 PM
      Subject: howard spinet


      Hi Guys,
      Came across a baldwin howard spinet with jack flanges that are =
comming unglued. I want to pull the action, but it was designed in a way =
I have yet to see.
      Bolted to the plate-no struts, and these long flat metal pieces =
that are screwed into the wooden platform under the action.
      Anything I should be aware of other than the usual stuff? Also , =
will the pianotek sticker holder work on this model?
      Thanks,
      RU/UP
---------------------- multipart/alternative attachment
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/6d/ff/be/4c/attachment.htm

---------------------- multipart/alternative attachment--