Hello Gordon. I do this routinely, without catastrophies. Because no other way gets me satisfied, uptill now. Best regards, Stéphane Collin. ----- Original Message ----- From: "gordon stelter" <lclgcnp@yahoo.com> To: "Pianotech" <pianotech@ptg.org> Sent: Sunday, August 21, 2005 7:19 PM Subject: Re: Stain Stripping > Sorry, Stefan. He'll never sand to "bare wood" without > going through the veneer, and generally making a mess > out of it. DO NOT NEVER EVER ATTEMPT TO EVEN THE TONE > OF VENEERED WOOD BY SANDING !!!!!!!!! > You will sand through, end up with concavities, etc.. > > --- Stéphane Collin <collin.s@skynet.be> wrote: > >> Hello Terry. >> >> I would sand to bare wood (carefully) and restain. >> (But who am I ?) >> >> Best wishes. >> >> Stéphane Collin. >> ----- Original Message ----- >> From: Farrell >> To: Mailing list for piano refinishers. ; >> pianotech@ptg.org >> Sent: Sunday, August 21, 2005 6:39 PM >> Subject: Stain Stripping >> >> >> I stripped the finish off the inside of the case >> (rim) of a piano I am working on. I used a >> methylene-chloride-free product called Dyna-Strip 2, >> sold by Pianolac. One application of stripper left >> on overnight removed the finish completely - it >> literally fell off - no scraping required at all. >> I'm very happy with that aspect of the results. >> >> In some areas, hunks of the stripper slid down the >> face of the rim - it still removed the finish - but >> in those areas, less stain was removed. So now I >> have shadows of light and dark where there was an >> apparent difference in stain removal. >> >> What is the best way to address these stain >> shadows? >> >> Terry Farrell >> >> >> >> > > > __________________________________________________ > Do You Yahoo!? > Tired of spam? Yahoo! Mail has the best spam protection around > http://mail.yahoo.com
This PTG archive page provided courtesy of Moy Piano Service, LLC