Tips for knuckle relocation

[Erwinspiano at aol.com]

Jon
  I have one & the blade & you may borrow it if you  wish.
  Dale

I've  dodged the bullet so far but there is an upcoming job in which the
owner  wants to keep the hammers from a previous rebuild (old shanks).

I'm  speculating that moving the knuckle from 15.5 to either 16 or 17 mm
will  accomplish desired touch weigh results.

Are there plans for a jig or a  floating-loaner jig for such a task?

I haven't  even determined if  I have a saw blade of the appropriate width.
Feedback on what I'm in for is  appreciated.
-- 

Regards,

Jon Page


 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://www.moypiano.com/ptg/pianotech.php/attachments/20060405/57881cec/attachment.html