This is a multi-part message in MIME format. ---------------------- multipart/related attachment ------=_NextPart_001_00A7_01C62915.9D4B07F0 Terry, Does mass loading the bridge work for the high treble end as well? Tom Servinsky ----- Original Message -----=20 From: Farrell=20 To: Pianotech List=20 Sent: Friday, February 03, 2006 11:13 AM Subject: Re: Mass Loading Bridges Here is a pictures of an assortment of brass-mass - all done from = round stock, bandsaw and small drill press. Below is picture of them installed. Terry Farrell ----- Original Message -----=20 > I'm finally getting around to working on the piano which had a boomy = > crossover from the long bridge to the bass bridge. I'm envisioning=20 > getting some rolled brass stock and cutting off pieces for=20 > this. I've cut aluminum with a carbide blade, I think brass might = be=20 > a little harder. How difficult is this to do? I'd drill a screw=20 > hole in the center and temporarily set under the bridge until I get=20 > the impedance I want. >=20 > How do you pro's do this? Where do you source your material and = what=20 > is your favorite means of machining it? >=20 > Andrew Anderson ------=_NextPart_001_00A7_01C62915.9D4B07F0 An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/70/d9/83/c2/attachment.htm ------=_NextPart_001_00A7_01C62915.9D4B07F0-- ---------------------- multipart/related attachment A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 47254 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/90/2f/51/05/attachment.jpe ---------------------- multipart/related attachment A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 39133 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/1c/91/5d/af/attachment.jpe ---------------------- multipart/related attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC