This is a multi-part message in MIME format. ---------------------- multipart/related attachment ------=_NextPart_001_003F_01C628B2.D42A27A0 Here is a pictures of an assortment of brass-mass - all done from round = stock, bandsaw and small drill press. Below is picture of them installed. Terry Farrell ----- Original Message -----=20 > I'm finally getting around to working on the piano which had a boomy=20 > crossover from the long bridge to the bass bridge. I'm envisioning=20 > getting some rolled brass stock and cutting off pieces for=20 > this. I've cut aluminum with a carbide blade, I think brass might be=20 > a little harder. How difficult is this to do? I'd drill a screw=20 > hole in the center and temporarily set under the bridge until I get=20 > the impedance I want. >=20 > How do you pro's do this? Where do you source your material and what=20 > is your favorite means of machining it? >=20 > Andrew Anderson ------=_NextPart_001_003F_01C628B2.D42A27A0 An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/96/92/63/81/attachment.htm ------=_NextPart_001_003F_01C628B2.D42A27A0-- ---------------------- multipart/related attachment A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 47254 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/88/ee/09/6b/attachment.jpe ---------------------- multipart/related attachment A non-text attachment was scrubbed... Name: not available Type: image/jpeg Size: 39133 bytes Desc: not available Url : https://www.moypiano.com/ptg/pianotech.php/attachments/de/a2/61/c1/attachment.jpe ---------------------- multipart/related attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC