Geeezzzzzz, here's another one! Of course! We should also check to see if there is any crown to the soundboard, etc. The dude was asking about notching and pinning - planing down to string groove base will not change downbearing. Terry Farrell ----- Original Message ----- > Shouldnt we be thinking about making sure there is enough downbearing to > do this ?? Just a tanke :) > > Cheers > RicB > > ---------- > Terry the Farrel writes: > > If you are not going to recap, then simply plane the top of the cap down > to > the string imprint depth, renotch to mid-pin line, put a couple drops of > thin epoxy down bridge pin holes, dip new pin in epoxy and insert pin into > hole. Clean up squeeze out with acetone. >
This PTG archive page provided courtesy of Moy Piano Service, LLC