I don't loose much sleep over string grooves either - I usually am installing new bridges with new epoxy-laminated caps! Terry Farrell ----- Original Message ----- > << > If you are not going to recap, then simply plane the top of the cap > down > to >> the string imprint depth, >> > > I can read this as saying to plane down to the very bit of string > groove. This doesn't reduce bearing if you leave the center of the old > string > groove, that is where the string was before! > I don't worry about the string grooves in the caps as much as I do > about > the definition of the notches. > > Ed Foote RPT
This PTG archive page provided courtesy of Moy Piano Service, LLC