> I recall that at Baldwin, about 15 years ago, they used a go-no-go gauge > which was used to check each and every tuning pin that was used in their > grand production. If I remember correctly, it was discovered that rolled > pins tended to be slightly out-of round (oval shaped in cross section), and > less so with cut threads. That was certainly my experience. Out of round, tapered top to bottom, or bottom to top, and ranging + - 0.003" or more from one to the next, depending on where you measured. The current cut thread stuff is much more uniform. It's been a long time since I had to mic and sort a set. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC