Hi, Now if you are going to do the twist, first twistthe wrong way then back. Try it you will like it. Joe Goss RPT Mother Goose Tools imatunr at srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "John Dutton" <duttonjw at gmail.com> To: "'Pianotech List'" <pianotech at ptg.org> Sent: Sunday, April 22, 2007 7:05 PM Subject: RE: Enlivening bass strings > Like Duaine I have had success with this same method except that I only > remove the string from the bottom hitch. I generally try to keep the loop > in the 6-8" diameter range. This process is described also in Reblitz 2nd > edition on page 116. After I do this I try to give a twist or two in the > direction of the windings prior to reattaching to the hitch pin. > > John Dutton > Billings, MT > > -----Original Message----- > From: Hechler Family [mailto:dahechler at charter.net] > Sent: Sunday, 22 April, 2007 14:44 > To: Pianotech List > Subject: Re: Enlivening bass strings > > Richard, > > My mentor showed me a way but it's hard to describe so I'll make an > attempt at it. > > First, completely take out the string. Then take the string a form a > over-under loop (like the first part of tying your shoe laces) fairly > tight but not enough to loosen the winding. Then roll the "loop" up and > down the full length of the string. > > This will loosen and should remove all the dirt that has built up -in- > the windings. > > Like I said it is hard to describe in words > > Duaine >
This PTG archive page provided courtesy of Moy Piano Service, LLC