Baoli, I had a similar problem in a Kawai some years ago. Upon the advice of one of the esteemed contributors on the list that we are on ( I cannot remember the technicians name) his advise was to make a new one out of rock maple pinblock material. Mostly with table saw cuts, some routing and a few coats of epoxy over the surface I was able to duplicate the lever and it is still in service today in the church sanctuary. This piano gets used hard and the lever has not split or warped. Good luck! David C. ----- Original Message ----- From: "Mike Kurta" <mkurta at adelphia.net> To: "Pianotech List" <pianotech at ptg.org> Sent: Tuesday, April 24, 2007 5:28 PM Subject: Re: Shift lever for Mason BB > Baoli, the same holds true for a cast iron pedal, brazing is the way to > go, except in this case some reinforcing is in order on the underside of > the pedal to strengthen it. If you can get a new one, all the better, but > if not, again a good welder should be able to make it better than new. If > you get stuck send it to me. > Mike >
This PTG archive page provided courtesy of Moy Piano Service, LLC