Greg writes: << . I've forgotten the numbers but remember these are Steinway parts. I wouldn't expect to get something too far out here. >> (ahem), Steinway offers a variety of parts,and there have been stock parts sent me that certainly did not fit. The jack/hammerflange contact is not unheard of. Your problem is more likely in the rails than the parts. If the hammerflange rail is just slightly rotated, there is interference. The pin to pin distance may be correct, but the flange will be out of place. Ususally when this happens, the drop screws are turned all the way up. If no new parts are available, you can often stop the problem by removing the proximal half of the jack, near the top. Regards, Ed Foote RPT http://www.uk-piano.org/edfoote/index.html www.uk-piano.org/edfoote/well_tempered_piano.html <BR><BR><BR>**************************************<BR> See what's new at http://www.aol.com</HTML>
This PTG archive page provided courtesy of Moy Piano Service, LLC