On Thu, Dec 4, 2008 at 5:09 PM, Ron Nossaman <rnossaman at cox.net> wrote: > > I don't recall that happening when I've done it, but I only had to do it a >> couple of times. I wonder if a drop of CA glue after pin insertion would >> freeze the bushings to prevent splitting. I don't see how it could hurt. >> >> Dean >> > > Might work. I was thinking maybe soaking them in a hard drying varnish > instead of water. Or even just leave them out. > Ron N > > I used the varnish, oil based and it worked the one time I tried it, soaked them in it, let 'em dry then strung with them. The next time I tried it it didn't, go figure! Mike -- I intend to live forever. So far, so good. Steven Wright Michael Magness Magness Piano Service 608-786-4404 www.IFixPianos.com email mike at ifixpianos.com -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20081204/7da63fde/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC