Don't know, but you can consider tapping the holes for the appropriate thread. Terry Farrell ----- Original Message ----- From: Gene Nelson To: pianotech at ptg.org Sent: Tuesday, December 23, 2008 12:35 PM Subject: [pianotech] but will it split Hello list, I am curious if anyone has ever installed damper lift lever capstans into a Renner back action replacement tray? As the tray grains are verticle with many glue joints (must be pin block material) I am a bit hesitant to try this. An end piece of a previous installation split quite easily but it was being pounded on lightly. Gene -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech_ptg.org/attachments/20081223/a04e57ee/attachment.html>
This PTG archive page provided courtesy of Moy Piano Service, LLC