ooh Ric, You're touching on trade secret territory here. You might just have to divulge your Credit card number to get answers. The Internet is a free for all but unfortunately not all for free. AF ----- Original Message ----- From: "Richard Brekne" <ricb at pianostemmer.no> > Please then, by all means expound. How much compression is imparted into > the panel with a typical RC&S design you are working with when down > bearing is applied so as to take the board to with in 75 % of flat... i.e. > leaving 25 % of original crown. Take a panel dried to 6.5 %... specify > the rib radii for a three or four areas of the panel. How do you > calculate the degree of compression created ? This is a point I think > many of us would benefit from. > > Cheers > RicB
This PTG archive page provided courtesy of Moy Piano Service, LLC