[pianotech] Replacing plastic elbows

[Carlos Ralon]

I still have some of those little inserts that were sold to glue/fit into 
suspisious elbows, saving replacment. I'll put them in the same box with the 
bronze tuning pin shims. If some of you are worried about the new plastic 
elbows, you could glue these little inserts in them.
Carlos Ralon, RPT
----- Original Message ----- 
From: "Jon Page" <jonpage at comcast.net>
To: <pianotech at ptg.org>
Sent: Tuesday, December 08, 2009 8:07 AM
Subject: Re: [pianotech] Replacing plastic elbows


> As far as using plastic or wooden elbows for longevity, heck;
> the plastic will outlive the piano at this point so as I said before:
> wooden elbows are not cost effective.
> -- 
>
> Regards,
>
> Jon Page
>
>