Matthew, This is more detail from our discussion three weeks ago. You must have been away from the list that week or you wouldn't have asked a question that was under such recent discussion. Check out the other postings from 11-20- 09 through 11-21- 09 Al Guecia among others had some suggestions . List, I'm a little late to this thread but several years ago I fashioned a tool for swedgeing loose damper leads from an 11". 45 degree needle nose pliers such as at this web site. http://www.sjdiscounttools.com/kti51211.html I put the thing in a vice and gave the tips a few judicious wacks then dressed the tips a bit . I think the fact that this is an inexpensive tool worked to my advantage as it was pretty malleable and the 45 degree angle gives good access to the levers. I make three or four dimples around the edge of the lead and it does the job. I've made a few of these for some fellow techs with positive reports back. Under ten bucks and no need to C.A. Tom Driscoll -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091215/034a5f24/attachment-0001.htm> -------------- next part -------------- A non-text attachment was scrubbed... Name: sjdiscounttools_2079_400547984.jpeg Type: image/jpeg Size: 25386 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091215/034a5f24/attachment-0003.jpeg> -------------- next part -------------- A non-text attachment was scrubbed... Name: P1010001-1.JPG Type: image/jpeg Size: 179050 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091215/034a5f24/attachment-0004.jpeg> -------------- next part -------------- A non-text attachment was scrubbed... Name: P1010002-1.JPG Type: image/jpeg Size: 267003 bytes Desc: not available URL: <http://ptg.org/pipermail/pianotech.php/attachments/20091215/034a5f24/attachment-0005.jpeg>
This PTG archive page provided courtesy of Moy Piano Service, LLC