Or use my bushing cloth tool. You will only need to form the taper. No gluing needed. Not on the site. Joe Goss BSMusEd MMusEd RPT imatunr at srvinet.com www.mothergoosetools.com ----- Original Message ----- From: "Jon Page" <jonpage at comcast.net> To: <pianotech at ptg.org> Sent: Friday, February 12, 2010 4:59 PM Subject: Re: [pianotech] Damper Spring Cord > I'm getting into this late and have not read all posts but to make an > appropriately sized cord there is a specific procedure. > > You want the lead end to be pointed to insert into the flange. To > accomplish this, start with a length of stranded cord and pull numerous > strands from the non-lead end to maybe 2". Pull numerous other strands > to 1". Pull the lead end sleeve taut to a point. You get the picture. > > Pull which0-ever various strands to different lengths to create a > graduated taper. > > Harden the lead end with your favorite glue in order to thread it through > the > flange yokes. > -- > > Regards, > > Jon Page
This PTG archive page provided courtesy of Moy Piano Service, LLC