Let me emphasize what Tom just said about regulation. Your post did not mention when her piano was last regulated, i. e. what is the present state of regulation. That's your starting point to establishing her needs. All the suggestions made thus far are good, and the cleaning and lubrication and polishing suggested is part of regulation for many of us. If her piano has not been regulated recently, begin there, and then proceed to other options as needed. You may well meet many of her needs simply by doing good close regulation and reducing friction. Will Truitt From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Tom Driscoll Sent: Tuesday, January 05, 2010 7:47 PM To: pianotech at ptg.org Subject: Re: [pianotech] Best way to change touch on Yamaha Grand Martin, Ditto on Mr. Monroes post on friction.. I performed a day of service on a same size kawai last week that played like a truck.I list in no particular order and at the risk of leaving something out: Lube and bed keyframe, Lube keypins and ease keys at balance hole and bushings, Polish capstans and lube , lube rep lever and jacks,knuckles ,wippen cushions and what ever else you can find,reshape hammers and REGULATE. Jacks too far under knuckles for example will make letoff very "resistant" Sample work up one note with touch weight before and after and more importantly let the client feel the difference. Dampers lifting too early with the key could be a problem also. Just a few ideas, Tom Driscoll Subject: Re: [pianotech] Best way to change touch on Yamaha Grand Hi Martin, Probably a can of worms here, as there really isn't a "right" thing to do without first considering a few things. I think my first diagnostic would be to assess the friction in the action, and eliminate as much as possible, lubing keypins/bushings, repinning hammers to a low friction level, say 3-4g. I'd also want to check knuckle condition and bolster/replace and lube them as well. My second diagnostic would be to find out how married your client is to the current tone of the piano. Lightening the hammers gets you great benefit for little cost, but will also change the tone and projection/power of the piano. Presumably with a 5'3" piano we're not "real" concerned about projection, but it's something to consider. If the tone is weak, consider filing/shaping hammers and possibly hardening them. The resulting brighter tone really can make the piano "easier" to play. Having done this, one is able to work less hard to achieve a particular dynamic level. There are a number of more elaborate geometry solutions that may help, including adjusting knuckle placement or capstan position among others. I'd also want to take a look at the leading and see if I couldn't remove a lead from each key, thereby reducing inertia. Often high inertia, low DW pianos play harder than lower inertia, higher DW pianos. Perhaps others will fill in more here. I wouldn't consider myself an "expert" on action geometry, I just know enough to be dangerous. ;-] Hope this gives you a start. I think it's really a lot of individual assessment, though with the particular piano in question. William R. Monroe On Tue, Jan 5, 2010 at 5:37 PM, martin cipolla <pianodoctor at msn.com> wrote: My client has developed arthrits and needs to have the action quite a bit lighter on her 5` 3`` Yamaha Grand. This is not something I have done before and would appreciate any suggestions on how to lighten the touch for her. Thanks, Marty -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100105/22194d97/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC