It's apPaulLing to me how many Paul's there are in this biz... On Wed, Jan 27, 2010 at 3:20 PM, Paul T Williams < pwilliams4 at unlnotes.unl.edu> wrote: > Aren't all of we "Paul's" great help? (most of the time) > > Paul > > > > From: > "Paul Milesi, RPT" <paul at pmpiano.com> > To: PTG Pianotech List <pianotech at ptg.org> Date: 01/27/2010 02:27 PM > Subject: Re: [pianotech] Modified Spade Bit was Chickering Pedal Lyre > ------------------------------ > > > > Thanks, Paul! (Please note there was one photo that didn’t come up; > perhaps you forgot to upload it?) > > Big help! Many thanks to all for the great lessons and insights to help me > do a beautiful job! > > Paul > > Paul Milesi, RPT > Washington, DC > (202) 667-3136 > E-mail: paul at pmpiano.com > Website: *http://www.pmpiano.com* <http://www.pmpiano.com/> > > > ------------------------------ > *From: *paul bruesch <paul at bruesch.net>* > Reply-To: *<pianotech at ptg.org>* > Date: *Wed, 27 Jan 2010 13:41:58 -0600* > To: *<pianotech at ptg.org>* > Subject: *Re: [pianotech] Modified Spade Bit was Chickering Pedal Lyre > > Tom Cobble sent me a series of photos of this very procedure a few years > ago. I've never used it, but here are my choices of those photos to best > demonstrate the procedure (for us rookies!) > > If you hover over any given photo a little description will display. > * > **http://www.pianotonix.com/grandLyreFix.htm*<http://www.pianotonix.com/grandLyreFix.htm> > > The initial through-hole should be as close to the diameter of the spade > bit as possible, without being smaller... a little larger is ideal. After > boring out the recess for the T-nut, you can chase out the through-hole to > the diameter needed for the T-nut. > > (Gracias, Tio Tom!!) > > Paul Bruesch > Stillwater, MN > > > > > -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100127/aaa74228/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC