[pianotech] Modified Spade Bit was Chickering Pedal Lyre

[Paul T Williams]

I aPaulogize!!

Paul




From:
paul bruesch <paul at bruesch.net>
To:
pianotech at ptg.org
Date:
01/27/2010 04:11 PM
Subject:
Re: [pianotech] Modified Spade Bit was Chickering Pedal Lyre



It's apPaulLing to me how many Paul's there are in this biz... 

On Wed, Jan 27, 2010 at 3:20 PM, Paul T Williams <
pwilliams4 at unlnotes.unl.edu> wrote:
Aren't all of we "Paul's" great help? (most of the time) 

Paul 



From: 
"Paul Milesi, RPT" <paul at pmpiano.com> 
To: 
PTG Pianotech List <pianotech at ptg.org> 
Date: 
01/27/2010 02:27 PM
Subject: 
Re: [pianotech] Modified Spade Bit was Chickering Pedal Lyre





Thanks, Paul!  (Please note there was one photo that didn’t come up; 
perhaps you forgot to upload it?)

Big help!  Many thanks to all for the great lessons and insights to help 
me do a beautiful job!

Paul

Paul Milesi, RPT
Washington, DC
(202) 667-3136
E-mail:  paul at pmpiano.com
Website:  http://www.pmpiano.com


From: paul bruesch <paul at bruesch.net>
Reply-To: <pianotech at ptg.org>
Date: Wed, 27 Jan 2010 13:41:58 -0600
To: <pianotech at ptg.org>
Subject: Re: [pianotech] Modified Spade Bit was Chickering Pedal Lyre

Tom Cobble sent me a series of photos of this very procedure a few years 
ago. I've never used it, but here are my choices of those photos to best 
demonstrate the procedure (for us rookies!) 

If you hover over any given photo a little description will display.

http://www.pianotonix.com/grandLyreFix.htm

The initial through-hole should be as close to the diameter of the spade 
bit as possible, without being smaller... a little larger is ideal.  After 
boring out the recess for the T-nut, you can chase out the through-hole to 
the diameter needed for the T-nut.

(Gracias, Tio Tom!!)

Paul Bruesch
Stillwater, MN







-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://ptg.org/pipermail/pianotech.php/attachments/20100127/6003ff6c/attachment-0001.htm>