[pianotech] Removal

[Phil Frankenberg]

You can use masking tape to help with re-installation. Run the tape across 
the upright stickers and around the end brackets. When the action is in, 
pull off the tape.


Phil Frankenberg
CSUChico
Chico, Ca.

----- Original Message ----- 
From: "Jon Page" <jonpage at comcast.net>
To: <pianotech at ptg.org>
Sent: Monday, June 28, 2010 2:13 PM
Subject: Re: [pianotech] Removal


> Pop the stickers out of the forks. Number and remove the keys.
> If you didn't have a rod to tie the stickers to the rail, do this:
> Insert sheets of newspaper from under the keybed and between
> the stickers, pull it up and over the balance rail pins. This will keep
> the dangling stickers from getting caught in the b/r pins.
> -- 
>
> Regards,
>
> Jon Page