Hello Everyone ~ I'm new to this list. It's fun to read all the stuff that goes back and forth. Last month I tuned a Baldwin Grand (dang, I didn't get the serial #) that had a pedal noise. The damper pedal had a sort of squeak where the lift rod sits in a rubber grommet. I could not lift the rod out of the grommet because there was a pin holding it in, like a center pin. I wanted to remove it so I could do a good job of lubricating it, but no luck. I tried to use my center pin tool, but the other pedal was too close and interfered. I ended up spraying dry teflon into it as I flexed it, trying to help the stuff get down into the grommet. It worked at the time, but the customer called back recently and said the sound was back. She said that other techs had fixed it before, but it comes back. I'm guessing they had the same problem I did. Perhaps it is necessary to remove the pedal lyre and disassemble it, remove the pedal and then use the centerpin tool on it? Anybody dealt with this before? Any ideas for getting the pin out in order to remove the lift rod? Loren Kelley
This PTG archive page provided courtesy of Moy Piano Service, LLC