Thanks all--- Found it in Schaff book... part no. 80. I feel silly that I have never seen this part. Guess I have more bedside reading to do. -John Parham > -------- Original Message -------- > Subject: Re: [pianotech] Using a burn in knife to repair lacquer > From: John Ross <jrpiano at eastlink.ca> > Date: Wed, January 12, 2011 5:19 pm > To: pianotech at ptg.org > > > Can't put my hands on my Schaff catalogue, but American Piano Supply Co. had them, electric Burn -In Knife part #511767. > Schaff bought their inventory, so quote yhat number if you want one. > John Ross > Windsor, Nova Scotia. > On 2011-01-12, at 5:51 PM, Gary Doudna wrote: > > > > > > > On Wed, Jan 12, 2011 at 12:34 PM, <johnparham at piano88.com> wrote: > > Paul, > > > > "just make sure your knife isn't too hot, so use a > > lamp dimmer to bring down the voltage." > > > > I understand the concept here, but have never seen a knife hooked up to > > an electrical source. Do you have a picture of your set up? > > > > -John Parham > > > > > -------- Original Message -------- > > > Subject: Re: [pianotech] Using a burn in knife to repair lacquer > > > From: "Paul McCloud" <pmc033 at earthlink.net> > > > Date: Wed, January 12, 2011 11:11 am > > > To: pianotech at ptg.org > > > > > > > > > Some years ago I had a video from Mohawk that was excellent. I don't have > > > any contact info handy, but they probably have that video still available. > > > I bet if you check You Tube there will be plenty of stuff there too. > > > I do a lot of this type of repair. It's not that hard. If you have the > > > equipment and sticks, just make sure your knife isn't too hot, so use a > > > lamp dimmer to bring down the voltage. When you touch the knife to the > > > stick, it shouldn't bubble. Put burn-in balm (looks like vaseline) around > > > the area. Melt the stick into the hole. Level using the knife blade > > > across the hole. You can use a single-edge blade to scrape it level if you > > > like, but be careful not to scratch the area around the damage. Sand > > > level, match the sheen with steel wool or polish if it's higher gloss. > > > Black sticks never seem to match the black, it always looks grey-er, so > > > don't expect a perfect repair. > > > Have fun (yet?) > > > Paul McCloud > > > San Diego > > > > > > > > > > [Original Message] > > > > From: David Love <davidlovepianos at comcast.net> > > > > To: <pianotech at ptg.org> > > > > Date: 01/12/2011 7:07:30 AM > > > > Subject: [pianotech] Using a burn in knife to repair lacquer > > > > > > > > Does anyone know of a good pamphlet or instructional video on how to use a > > > > burn in knife to repair lacquer (black). I need to make a small repair > > > but > > > > finish stuff is not in my area of expertise. > > > > > > > > David Love > > > > www.davidlovepianos.com > > > > > > > > > > > > I need advice on touch-up for the edges of a black, satin 2003 Steinway "S". Some edges have worn through and need to be matched to the original finish. > > Thanks, > > Gary > > > > -- > > Doudnas > > PO Box 68 > > Baileys Harbor, WI 54202 > > Doudna440 at gmail.com > > > >
This PTG archive page provided courtesy of Moy Piano Service, LLC