On 7/15/2011 11:28 AM, David Renaud wrote: > > Ron said..... > >> Or you can cut out the inner rim underneath the block and attack it from the bottom. > > Nice, yes, of course...... > This plate screw is located just shy of the shelf....and far enough from any tuning pin holes I could actually drill up from the bottom. > Flexible shaft........drill up.....plug/fill, start over from the top. Sounds like an excellent plan. If you can get in there with a deep, say 3/4" hole saw without a pilot bit, you can straddle all the broken hardware and get out a clean full depth plug. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC