Upright piano............................... -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Thursday, November 10, 2011 10:01 PM To: pianotech at ptg.org Subject: Re: [pianotech] help please On 11/10/2011 8:53 PM, Greg Newell wrote: > I'm confused here. It looks like you've drilled every one. How is that > somehow better or less time consuming than just flipping the piano over with > action removed and applying CA from the underside of the block? It seems to > me like a better way to apply too since you're putting the CA directly onto > the pin/block contact with little chance of gluing the block to the plate as > was described in a thread a bit ago. Suit yourself but, the very last place I want the pins tight is at the bottom of the hole. Ron N ----- No virus found in this message. Checked by AVG - www.avg.com Version: 2012.0.1869 / Virus Database: 2092/4608 - Release Date: 11/10/11 ----- No virus found in this message. Checked by AVG - www.avg.com Version: 2012.0.1869 / Virus Database: 2092/4608 - Release Date: 11/10/11
This PTG archive page provided courtesy of Moy Piano Service, LLC