Gene You can make a screw driver as Joe suggested. But the way I used to remove these nuts is by gently tapping on one side of the nut with a small screw driver blade. Depending on how tight it is, determines the size of the hammer, and the force used to loosen it. Wim -----Original Message----- From: Gene Nelson <nelsong at intune88.com> To: pianotech <pianotech at ptg.org> Sent: Wed, Jun 27, 2012 5:52 pm Subject: [pianotech] is there a tool for this Any ideas how to unscrew this? s there a tool made just for this? ny home made tool designs someone might want to share? wo #10 WNG bridge pins fit into each recess but will not budge it when I urned them with a big crescent wrench. ossibly some square steel rod that fit a bit better would be helpful. hanks, ene -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20120628/2fa95518/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC