Paul Before you remove the pins, tape a hammer shank against the side of your tuning pin punch, so that the shank touches the plate. Wim -----Original Message----- From: Paul Mulik <paulmulik at yahoo.com> To: pianotech <pianotech at ptg.org> Sent: Fri, Nov 2, 2012 2:31 am Subject: [pianotech] Tuning pin height I'm going to be restringing a piano next week and I would like suggestions on how to make sure all the new tuning pins end up at the same height. Thanks, Paul Mulik Sent from my U.S. Cellular BlackBerry® smartphone -------------- next part -------------- An HTML attachment was scrubbed... URL: <https://www.moypiano.com/ptg/pianotech.php/attachments/20121102/b36ad065/attachment.htm>
This PTG archive page provided courtesy of Moy Piano Service, LLC