[pianotech] Damper Lift Rail Flange Screw Access

[Terry Farrell]

Grrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr.

On Oct 10, 2012, at 8:42 PM, Joseph Garrett wrote:

> Terry The Farrell said: 
> "Is there any better way to remove/install screws on an Korean piano's
> damper lift rail flange screws other than go at them at an inefficient
> angle? Is there some tool that I'm obviously not aware of that makes
> getting in there a piece of cake?" 
> Thanks!
> 
> Terry,
> Hmmm? I'd use either a stubby screw driver or an offset screwdriver,
> (ratchet type, made by General), to remove the Vertical Screw first.Then
> lift the lever and straight access to the horizontal one.<G>
> Joe
> 
> 
> Joe Garrett, R.P.T.
> Captain of the Tool Police
> Squares R I
>