On 2/15/2013 1:03 PM, Susan Kline wrote: > Joe, that's an extremely cute trick with the pin vise and the drill press. > Thanks for sharing it! I have a 0-1/4" chuck on a 3/8" shank that I've used forever for those little bits in the drill press. More versatile than a pin vise, and harder to lose. For me, that's a factor. Or you can go to Micro-Mark and get a #81852 #59-1/8" chuck on a hex shank that will go in either your cordless screwdriver or drill press, for $11.50. Lots of ways to skin this moose. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC