Thanks Ron and Jurgen for your comments. Will -----Original Message----- From: pianotech-bounces at ptg.org [mailto:pianotech-bounces at ptg.org] On Behalf Of Ron Nossaman Sent: Friday, February 15, 2013 12:54 PM To: pianotech at ptg.org Subject: Re: [pianotech] 1098 Hammer Bore On 2/15/2013 11:12 AM, Jurgen Goering wrote: > I sent this yesterday, but it is not showing up. I will re-send at > the risk of having both posts appear... I apologize if they do. > > > On any upright, the bore is never calculated as below. Otherwise, as > has been alluded, the hammer shank would be vertical when the hammer > meets the string. A ballpark hammer bore determination for an upright > would > be: String to center pin distance less blow distance plus 5.5 mm (7/32"). Or, reproduce the rake angle in deviation from parallel of the shank to the strings (with the hammer perpendicular to the string) and measure the resulting bore distance. Ron N
This PTG archive page provided courtesy of Moy Piano Service, LLC