Don, This is an unsolicited testimonial for the "Dampp Chaser Canadian Research Institute" (aka Mark Cramer). By the time Cramer feels something is worth posting on a forum such as this, you must know that he has thought things through and tested endlessly to prove its merit. I did a 'hybrid' installation using heat'n'bond on the curved profiles and PSA velcro strips on the straight edges (bass and belly rail). This allows quick access to the pads for the 'ham-fisted' among us (aka ... me). This being said, Mark has demonstrated just how #@$%* easy it is to install, remove, install, remove the heat'n'bond with the little travel iron many of us carry in our kits. TTFN, Stan Kroeker, RPT Don wrote: > Hi, > > I have been recommending to my clients that pads be changed four times > yearly. The iron on semi permanent fix would make this even more of a > hassle than it already is. > > I could I suppose use velcro for only the straight sides and the heat > bonding tape for the other sides---or maybe make a "half moon" that is > velcro so the client could still access the pads. > > I want my clients to be very "hands on". > > At 12:12 PM 6/23/2005 -0500, you wrote: > >>Thanks to everyone who dropped by the Dampp-Chaser booth in KC to see our >>install demonstration. >> >>Roger asked for feedback regarding the "heat and bond method," so here's >>some of my own, from an install completed this just twenty minutes ago: >> >> >> >>KG-3c / Church Piano / G6PS-50 system plus 2-25w bars / still swings 25 >>cents @B2 seasonally! >> >>Arrived in the sanctuary at 11:15, finished and submitted my bill at 11:50. >> >>Thirty-five minutes to fit and trim the undercover... perhaps sooner, if the >>caretaker had taken my hint(s). >> >>Pre-stapled the bonding-tape around the rim for convenience. (feeling a bit >>shaking today, too much coffee!) >> >>Made sure to use the Heat n Bond product marked "SUPER" or "SUPER WEIGHT." >> >>Started fitting/ironing at the corner of the bass rim and belly rail, to >>take advantage of two straight sides. >> >>Saved loads of time, as only the treble and tail sides required trimming. >> >>Second pass all the way around with the warm iron, just to be sure. >> >>Done! >> >>Notes for next time: >> >>1.) Bring fleuro-trouble light, makes it easier to see where the bonding is >>and where to trim. >> >>2.) A dull knife isn't a knife! >> >>3.) Send the caretaker on a long errand while I'm working! ;>) >> >>best regards to all, >> >>Mark Cramer, >>Brandon University >> >> >>_______________________________________________ >>caut list info: https://www.moypiano.com/resources/#archives >> >> >>-- >>No virus found in this incoming message. >>Checked by AVG Anti-Virus. >>Version: 7.0.323 / Virus Database: 267.7.11/26 - Release Date: 6/22/2005 >> >> > > > Regards, > Don Rose, B.Mus., A.M.U.S., A.MUS., R.P.T. > Non calor sed umor est qui nobis incommodat > > mailto:pianotuna@yahoo.com http://us.geocities.com/drpt1948/ > > 3004 Grant Rd. REGINA, SK, S4S 5G7 > 306-352-3620 or 1-888-29t-uner > > _______________________________________________ > caut list info: https://www.moypiano.com/resources/#archives >
This PTG archive page provided courtesy of Moy Piano Service, LLC