Alan Crane wrote: >I've experienced this only once so far and called S&S about it. At >that time, they said to use epoxy to secure the u-pin back into its >holes in the sost. rod. I assume this would not be viable if it broke >off flush but I've never seen that...yet. I followed their advice and >have had no problem with that *one* since (six years and counting). I guess I should say that I have tried epoxy, and that I considered the results poor. A soldering pen does not produce nearly enough heat to liquify the solder used here. Thanks. Kent (home-with-a-sick-kid) Swafford
This PTG archive page provided courtesy of Moy Piano Service, LLC