Oorebeek A. wrote: > > >Bolts that hold the plate down? Hmm that couldn't have any thing to do > >with false beasts due to strings rising on the brigde pins, could it? Do > >you take bearing measurements in that case. How is the bearing then? > > > >Richard The Curious > > So, Richard the Curious, > Just a little note about this Kawai > Through my training at Yamaha, I have learned to do the following (when executing a thorough job) : Tighten all action screws, tighten all frame screws and bolts, tighten strings on hitch pins and bridges, make a complete regulation, tuning and voicing. > In this case, nothing of the above mentioned has ever been done. > And that's why I wrote this in my email. > I hope this satisfies your curiosity and brings you in a good Moody! > > BTW How are you doin! > > Friendly Greetings from: > > CONCERT PIANO SERVICE > André Oorebeek > Amsterdam, the Netherlands > email address: oorebeek@euronet.nl > > ‰ Where Music is no harm can be ‰ Andre', I would like to respectfully mention 2 things. In your post above you forgot to tighten and level string coils in your thorough job. Secondly could you please set the options on your e-mail package to wrap the characters at about 70 or so? Each post you send goes off the page! Thanks!! Greg --
This PTG archive page provided courtesy of Moy Piano Service, LLC