> Date: Thu, 15 May 1997 20:45:58 -0400 > From: delgit@acc-net.com (Gittinger, Delbert M.) > Subject: Re: SAT wish list > To: pianotech@byu.edu > Reply-to: pianotech@byu.edu A keypad for punching in numbers! ilvey Pacifica. Ca > > This thread looks like it's going in an interesting direction. My > > suggestions would be to make the readout more friendly in general. > First, > > I would like a readout of the partial that is being read. Second, a > > readout of the amount of offset in use - either programmed by the pitch > > raise calculator or manually. > > > > I'm sure I could think of more... but what's yours? > > > > Mark Story, RPT > > Eastern Washington University > > mstory@ewu.edu > > > My wish list for the SAT: > > 1> Be able to read the Header which contains the piano, ser. #, customer > name or whatever is there. > > 2> A visible indication of what mode the SAT is in - i.e. Tune, Memory, > Stretch, etc. > > 3> The note and/or the partial being measured. > > 4> I'd like to be able to read the FAC numbers for a stored tuning. > > and if we're getting real wild, as you suggest, multiple partial displays > at once. Of course that can be done now, just buy multiple SAT's and > parallel the foot/thumb switch to all of them. > > Del > > Del Gittinger, RPT > Registered Piano Technician > of the Piano Technicians Guild > delgit@acc-net.com > Marion, OH > >
This PTG archive page provided courtesy of Moy Piano Service, LLC