If I recall correctly, you wanted to know the length to make the tie-off from the winding allowing for stretch. When I order a string from measuring off existing wire, I allow 1/8" at the back and 1/4" at the front. (or was it 3/8?). So, in answer to your question, good luck. I succussfully made a splice on the back of A1 after a couple tries. Tricky. Measure the speaking length, measure the wrap length. Using the above 'stretch factor', place the tie-off where the winding will end up within hopefully equdistant ends. New England Piano String (formerly Tuner's - Sal) said that everyone uses pre-made tie-offs where they can make them to size. They are pretty good strings but do not have the qualities of GC (whose do). Jon Page Harwich Port, Cape Cod, Mass. (jpage@capecod.net) ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ ~~~~~~~~`~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC