Ah, I think I get it. How do you clamp your ribs to the panel? Go bars or something of that nature? Would you need to leave the little end on if you were using the pneumatic fire hose setup? Perhaps the fire hose won't fully press along such an uneven surface? Terry Farrell ----- Original Message ----- From: "Marcel Carey" <mcpiano@globetrotter.net> To: <pianotech@ptg.org> Sent: Wednesday, January 23, 2002 4:44 PM Subject: RE: Soundboard Press > No problem Terry, > > I use the band saw to taper the ribs roughly. I finish with the spoke shave > and sanding. I cut with the bandsaw and just before I get to the end of the > rib, I stop and back it up carefully. So, the rib is shaped, but not all the > way through. This leaves me with a more even surface to put pressure on the > glue joint. Hope you can see what I mean. > > Marcel Carey
This PTG archive page provided courtesy of Moy Piano Service, LLC