At 11:11 AM 6/10/2002 -0400, you wrote: >1) what is banding? Banding is the development of thicker portions of finish as a result of overlap from spraying in only one direction >2) When you speak of sanding direction you mean block sanding right? I >fail to see how sanding direction would help with a random orbit sander. Even with an orbital sander, overlap can cause thinner areas if the same sanding direction orientation is kept. >3) what do you use to pad the surface if you get a sag? A soft cloth (not terry cloth) wadded into a smooth blotter. Sometimes you get real lucky and it disappears. Regards, Jon Page, piano technician Harwich Port, Cape Cod, Mass. mailto:jonpage@attbi.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
This PTG archive page provided courtesy of Moy Piano Service, LLC