At 5:30 PM -0400 6/17/02, Phil Bondi wrote:
>it wasn't a tight jack flange...what was it?
Back check set so far back that, instead of checking the hammer tail,
it simply let the tail fly on down and lodge against the rep flange.
Hammer now 1/4" below its neighbors, shank pressed into the bumper
felt, jack pried out from under the knuckle (and possibly wedged
against it), and the rep lever pushed down.
Bill Ballard RPT
NH Chapter, P.T.G.
"I gotta go ta woik...."
...........Ian Shoales, Duck's Breath Mystery Theater
+++++++++++++++++++++
This PTG archive page provided courtesy of Moy Piano Service, LLC