Downbearing and Tone

Farrell mfarrel2@tampabay.rr.com
Fri, 14 Mar 2003 09:38:31 -0500


And also, you mention downbearing of one and one-half degrees, is measured only on the rear string segment? What are the angles back and front?

Terry Farrell
  
----- Original Message ----- 
From: "Farrell" <mfarrel2@tampabay.rr.com>
To: "Pianotech" <pianotech@ptg.org>
Sent: Friday, March 14, 2003 9:24 AM
Subject: Re: Downbearing and Tone


> What is the shape of the soundboard between each set of ribs? What was the shape with the strings off?
> 
> Terry Farrell
>   
> ----- Original Message ----- 
> From: "Mike Spalding" <mjbkspal@execpc.com>
> To: "Pianotech" <pianotech@ptg.org>
> Sent: Friday, March 14, 2003 9:13 AM
> Subject: Re: Downbearing and Tone
> 
> 
> Keith, David, List,
> 
> Mind if I jump in here with my own situation/question?  1929 M&H A, minor soundboard cracks behind bass bridge filled with epoxy, original caps in excellent shape, new bridge pins bedded in epoxy after planing and re-notching caps.  Re-set downbearing to 1 degree in treble tapering to 1/2 degree in tenor (not necessarily intentional, but that's the way it worked out).  F6 to F7 is clear and firm but very short sustain.  Abel Encores, have done some shoulder needling but don't want to over do it.  Is downbearing the likely culprit, or is there some other potential cause, or is this just the way it is?
> 
> Mike Spalding RPT
> 
>   ----- Original Message ----- 
>   From: Keith Roberts 
>   To: davidlovepianos@earthlink.net ; Pianotech 
>   Sent: Thursday, March 13, 2003 10:44 PM
>   Subject: Re: Downbearing and Tone
> 
> 
>   You would have to clue us in on a bunch of other factors.
>   What type of board? Old compression crowned board with a new, thicker bridge cap? Or a new board?
>   Keith Roberts
>     ----- Original Message ----- 
>     From: David Love 
>     To: Pianotech 
>     Sent: Thursday, March 13, 2003 5:42 PM
>     Subject: Downbearing and Tone
> 
> 
> 
>     How would you best describe the tonal characteristics of a piano that has too much versus too little down bearing?
> 
> 
>     David Love
>     davidlovepianos@earthlink.net
> 
> 
> _______________________________________________
> pianotech list info: https://www.moypiano.com/resources/#archives

This PTG archive page provided courtesy of Moy Piano Service, LLC