---------------------- multipart/alternative attachment In a message dated 10/23/03 12:31:40 PM, pianobuilders@olynet.com writes: >=20 > With this in mind I'm not sure what you mean when you say "a straighter wi= re=20 > gives truer harmonics." >=20 > =A0 >=20 > Baldwin uses straightened and pre-cut wire simply as a manufacturing=20 > expediency. These wires are purchased from Mapes to specification with eac= h coming=20 > bundled in a package of, perhaps, a hundred or so=A0identical wires labele= d for=20 > a specific spot on a specific piano. These are then placed in one of sever= al=20 > tubes set up so the stringer can pull whichever specific wire is needed in= =20 > sequence as stringing progresses. >=20 >=20 I have had a couple of technicians observe the wire is not perfectly straigh= t=20 in the last inch of travel into the agraffe, and measurements seem to confir= m=20 this. The theory is this acts like a shock absorber, or a mild kink, and=20 affects the string adversely. In fact strings are kinked daily by technician= s and=20 they don't re-straighten. I had thought Baldwin did this for tone quality's=20 sake, but it's obvious to me on reflection that indeed it's just for handlin= g=20 ease. I'm guessing Mapes used an industry standard straightener, and i'm sti= ll=20 wondering if roller pressure on the skin of the wire affects it for ill ? Glenn C. ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/d2/2e/65/5c/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC