This is a multi-part message in MIME format. ---------------------- multipart/alternative attachment I also soak the old bushings with a 5:1 wallpaper-remover: water solution from a hypo-oiler. After letting them sit for awhile, I come back and soak them again. Then I heat up my key-bushing iron to 200 degrees and using a tapered broach, insert it into the mortise - basically steaming each bushing individually. The bushings will then usually come out without too much fuss. R.Cromwell Chptr 481 _____ From: pianotech-bounces@ptg.org [mailto:pianotech-bounces@ptg.org] On Behalf Of lgulli2586 Sent: Wednesday, December 01, 2004 3:21 PM To: Pianotech Subject: Key Bushing removal Hi, I use the method of pre-soaking the keybushings with wallpaper remover and hot water and after that I just steam the bushings out with a similar hand held steam device with a small nozzle. Works verry fast and de wood is neat and clean for the new felt. Pierre Gevaert Belgium Hello....I use the same system...but let them penetrate and soak,,,,while I do some other job around the shop...an hour later they fall out with very little digging....and no damage to mortise...... Richard ---------------------- multipart/alternative attachment An HTML attachment was scrubbed... URL: https://www.moypiano.com/ptg/pianotech.php/attachments/75/6b/8d/cb/attachment.htm ---------------------- multipart/alternative attachment--
This PTG archive page provided courtesy of Moy Piano Service, LLC