Hi Arlie, Last time I needed one I wrote samick and they send back three--one of each type they have used. I did mention the serial number. I found them very accomodating. At 07:50 AM 18/12/2004 -0700, you wrote: >Yesterday on a Samick I serviced, I noticed the dampers were hardly >lifting off in the center of the piano. So I removed the action. One >of the damper rod pins was loose, not broken (fortunately). I intended >to replace it with a Schaff #545 damper rod pin, but these repair pins >are not compatible. I filled the hole with CA glue, stuck the pin back >in, and it held (I'm not holding my breath as to how long). If the pin >had been broken, I'm not sure what I would have done. > >Does anyone know a source for the Samick damper rod pins? The Samick >pins are a larger diameter on the end that enters the rod and a smaller >diameter on the other end that enters the hinge. > >Arlie Rauch Regards, Don Rose, B.Mus., A.M.U.S., A.MUS., R.P.T. Non calor sed umor est qui nobis incommodat mailto:pianotuna@accesscomm.ca http://us.geocities.com/drpt1948/ 3004 Grant Rd. REGINA, SK, S4S 5G7 306-352-3620 or 1-888-29t-uner
This PTG archive page provided courtesy of Moy Piano Service, LLC