TiteBond, or plain old Elmer's white glue, can be applied with a roller for consistency of thickness to both surfaces, then allowed to dry. Once it is dry the two pieces can be placed together and a clothes iron pressed over the surface, which temporarily re-melts the glue and sticks the pieces to gether. Its still a real pain on large surfaces to get everything fully flat, and I would REALLY like to hear from anyone who does this regularly and gets goodcresults! PLEASE! Thump --- Erwinspiano@aol.com wrote: > In a message dated 2/2/2004 8:45:52 PM Pacific > Standard Time, > ANRPiano@aol.com writes: > In a message dated 2/2/2004 7:19:39 PM Pacific > Standard Time, > tune4@earthlink.net writes: > Just curious: how do you plan to "glue" the veneer > to the core? Do you have > a press rigged up, use contact cement, use a hot > glue method, or use hot hide > glue? > I am getting to this now. I have two choices, my > first would be a vacuum > press, but I will need a larger bag than I have now, > I can do an 8 x 4, but need > 8.5 x 5.5 to have a comfortable fit. > > I have had mixed results with wood glues and vacuum > presses, I will > experiment first. If I can get it to work Tite bond > would be my choice because of the > open time. > > I may rig my pneumatic soundboard press for this, > but I may have to make some > modifications to accommodate the thickness of core, > veneer, and caul. > > On such a large surface I was thinking the paper > backed would be easier to > work with than standard veneer. I will probably > cross band it, simply to be on > the safe side. > > As far as laying up the core, it has been a simple > matter of cutting down the > larger pieces of material, alternating grain, > planing, edgeing, glueing two > pieces together at a time and trying to keep > everything as flat as possible. I > have used bisquets through the first two assembly > stages, while these are > handy for alignment, I think some of my alignment > problems can be traced to the > biscuits. So the bisquest have been a mixed > blessing. > > I will see about pictures. > > Andrew Remillard > Andrew-I believe its possible to coat both veneer & > lid with thin Hot hide > or is it tight bond, anyway & then Iron it firmly > into place. I'll check with > Bob Davis. I think he & Marcia have done this a few > times. This would be way > simpler than what I'm hearing proposed. > > > > Dale Erwin > Erwins Piano Restorations > 4721 Parker Rd, Modesto, Ca. 95357 > erwinspiano@aol.com > __________________________________ Do you Yahoo!? Yahoo! SiteBuilder - Free web site building tool. Try it! http://webhosting.yahoo.com/ps/sb/
This PTG archive page provided courtesy of Moy Piano Service, LLC